Meaning install a processor that supports a ton of ECC RAM and has really good single thread performance while having as many cores as possible as well as a workstation graphics card. This is also why it is recommended to use a PC that is designed to be a Workstation and not a Gaming system. If you choose to save it, it will wait to close Fusion360 till the local copy gets saved in the cloud. You can tell this is the case if you ever try to close the program with an unsaved model. What is done in the cloud are things like photo realistic 3D rendering and simulations. Most of the modeling and tool path work is done on your local PC. Yes Fusion360 is cloud based… for file management. Not a computer issue it’s it’s cloud based system. She just can’t reach around the spindle to screw it down. If I could find a way to get it to go to the back of the machine until commanded foward after the predrill for screws she could run the whole thing her self. So she can grab the next bit and check the amana part number and get it going gain. ![]() It says what bit number and I have a bit holder with the bits in order and a picture and description of each bit from the fusion setup sheet. I have some cuts which take hours and I am able to have my wife change bits for me if I need to leave. When it’s time for the next bit change it auto stops the spindle, brings it forward and repeat. ![]() Will run to bit setter, set bit height automatically, then start cutting automatically. ![]() Then I hit one button and close the enclosure. Then it comes front and center and calls for the next bit normally a larger roughing bit or a facing bit if I’m not using plywood. First bit is normally a 1/8” drill bit to pre drill hold down screw locations.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |